POWER SAVE
POWER-SAVE conditioning units have been lowering consumer electric bills by
as much as 25% for years. The technology has long
been used in industrial/commercial applications for a very long time, but the rapid
rise in home electricity costs has created unprecedented
consumer demand. The Power-Save unit work by conditioning the
inductive motor load and correcting the Power-Factor back to 1,
or as close as possible, thus eliminating wasted electrical
consumption.
Think of a car engine that is out of tune...
It's hard to start, gets poor performance, bad gas mileage and
pollutes the environment... generally costing you more money!
Did you know that pretty much all of your household appliances
are in the same boat??? Anything with an electric motor is
costing you more electricity than it really should!!! Think of
everything in your house that has a motor in it... from big
ticket items like your furnace and air conditioner to most of
your kitchen appliances to TV's and computers to everyday items
like room fans and hand tools to hairdryers and vacuums... the list just
goes on and on! Every one of these induction motors is costing you
money since all of them could use some amount of power
factor correction. In other words they need a tune up!
This is where POWER SAVE comes in. Just by
adding this unit it will automatically correct ALL these motors
to run the very best they can! They'll run more efficiently and
that means more money in your pocket, not the electric
companies! It's that simple! We've used one here as a field test
for over a year now and have noticed a savings in our electric
bill each and every month! It's paid for itself the first
year!!! How many other items have we purchased that we can say
that about... NONE! It's like getting a month or two FREE on our
bill from here on out!!! Also this unit acts to correct line
spikes, surges and sags for your whole house. That alone could
be worth the cost!
How's it install? It mounts next to your fuse
panel and uses an empty circuit breaker slot. An electrician
could easily install it in less than an hour. We installed our
own and it took about 90 minutes and that even included one trip
to the local hardware for a 20 amp breaker (for $5).
|
Whats All Included
In Your New PF Kit?
* Power Save 1200 Unit
* 1.5 FT Flex Conduit
* 2 Flex Couplers
* One Page
Instructions
NOTE: requires a 20
amp, 220v
breaker for your panel, not included
|
|
|
|
|
|
|
|
|
